A blog about electronics and programming

Home › Forums › Mastering STM32 book support forum › Hello World compiled and programmed


Viewing 1 post (of 1 total)
  • Author
    Posts
  • March 12, 2019 at 2:05 pm #11586
    mikkov82
    Participant

    Hi,

    I have succeeded to compile “Hello Wolrd” and also board programming doesn’t give any failures, but after then only LD1 blinks fast red and green. LD2 won’t go on.

    I haven’t done any measurements yet but I guess board isn’t running program correctly or it’s stucked some way.

    I have NUCLEO-F072RB board containing STM32F072RBT6 and I have expeted that PA5 is the correct port for LD2?

    Do I need to do something for Hello World code to get a timer working?

  • Author
    Posts

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.