A blog about electronics and programming

Home › Forums › Mastering STM32 book support forum › Windows 7 Toolchain GNU ARM Eclipse Question


Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 30, 2017 at 9:01 pm #5872
    LLH
    Participant

    Carmine’

    Installing Toolchain using Release .21 of the book looks fine up to page 58, Figure 8: GNU ARM plug-ins selection. Figure 7 results looks okay but after selecting GNU ARM plug-in to install, Figure 8 is different. Figures 7 and 8 captured from PC screen are attached. Any suggestions what to try next?

    Larry

    Attachments:
    You must be logged in to view attached files.
    January 30, 2017 at 9:41 pm #5879
    LLH
    Participant

    Hold the press. After following the “troubleshooting section” link in the Read carefully paragraph on page 59, the described fix cleared the problem. I had to change C:Program FilesJavajre1.8.0_121libsecurity subdirectory property to uncheck Read Only property to copy files. Running Windows Explorer as Administrator was required. For security purposes, can I change this subdirectory property back to Read Only now? Resulting Figure 8 is attached.

    Attachments:
    You must be logged in to view attached files.
    January 30, 2017 at 10:30 pm #5901
    Carmine Noviello
    Keymaster

    I’m not totally sure about that, but I think that it’s ok to revert to readonly access to that dir.

  • Author
    Posts

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.