[mklengel]

Jello Carmine,

I‘m a beginner regarding STM32 so forgive me my
possibly stupid question.

My setup consists of

NUCLEO-F746ZG Development Board
https://my.st.com/content/my_st_com/en/products/evaluation-tools/product-evaluation-tools/mcu-eval-tools/stm32-mcu-eval-tools/stm32-mcu-nucleo/nucleo-f746zg.html

X-NUCLEO-IDW01M1 WIFI Expansion Board
https://my.st.com/content/my_st_com/en/products/ecosystems/stm32-open-development-environment/stm32-nucleo-expansion-boards/stm32-ode-connect-hw/x-nucleo-idw01m1.html

X-NUCLEO-LED16A1 16 Channel LED Driver Expansion Board
https://my.st.com/content/my_st_com/en/products/ecosystems/stm32-open-development-environment/stm32-nucleo-expansion-boards/stm32-ode-power-drive-hw/x-nucleo-led16a1.html

STCubeMX doesn’t show any expansion board in addition
to the development board. Is there no initialization code for
the expansion boards necessary? I would expect the opposite.

What is the way to use such expansion boards?

Thanks in advance.

Regards
Michael

[Author]

Posts